Fusion Amp Family
Plate amplifiers can be used to quickly and easily convert passive loudspeakers into active ones, or to replace your passive filter design with a digital filter solution.
The gain can be trimmed in the HFD software, adjusting the gain and input buffer at the amplifier itselves is not supported.
https://hypex.millerpreview.nl/FAQ-Hypex/Fusion-Amp-Family/Can-I-adjust-the-gain-or-input-buffer-on-the-Fusion-Amp-Family
Our software (HFD) is available as a free download on our website.
https://hypex.millerpreview.nl/FAQ-Hypex/FAQ-Hypex/DSP-Family/Fusion-Amp-Family/I-bought-a-DSP-containing-product-where-can-I-find-the-software
No, it is not possible to add anything to the Fusion Amp setup, as doing so will void the warranty.
Here you will find some example hardware and software:
https://hypex.millerpreview.nl/FAQ-Hypex/FAQ-Hypex/Fusion-Amp-Family/DSP-Family/Which-microphone-and-software-can-I-use-to-measure-my-speakers-with-Hypex-DSP-solutions
Hardware:
- Dayton EMM-6
- Focusrite Scarlett Solo
It is important to use an external soundcard with microphone input.
Software:
- Hypex Filter Design
- Room EW Wizard software
Your Fusion amp is factory programmed, therefor a Fusion Amp cannot be changed afterwards. Adding an extra amplifier will result in a not working channel.
https://hypex.millerpreview.nl/FAQ-Hypex/Fusion-Amp-Family/I-need-a-third-channel-at-my-two-channel-Fusion-Amp-can-I-add-the-NC100HF-module
Check out our "Application page" for more information and support.
https://hypex.millerpreview.nl/FAQ-Hypex/Fusion-Amp-Family/Which-Fusion-Amp-Family-plate-amplifier-do-I-need-for-my-speakers
Out of the box, the Fusion Amp does not function for your safety and to protect your valuable speakers. Since the Fusion Amp’s DSP does not include a filter by default, you will need to start by using HFD. This free software can be downloaded from our website. You can familiarize yourself with the software, even without a Hypex product connected. A comprehensive guide on how to design the filters is available on our website under the "downloads" section.
Open HFD on your PC and connect your PC with the Fusion Amp. Open Filter design and choose “File” -> “New Fusion Amp” if you now choose “load filter to DSP” a unity filter will be uploaded. If you desire a different filter, please refer to the HFD manual.
https://hypex.millerpreview.nl/FAQ-Hypex/Fusion-Amp-Family/How-to-upload-a-filter-to-my-Fusion-amp